Thought some of you guys might be interested in the engine cover that I have available for the GTM's. This is the "Mike DeGuire" engine cover I have listed on my website under the "Custom GTM Parts" section. I realize that you guys are probably not interested in the big FF5 logo in the4 middle, but I'm thinking it would not be too difficult to come up with your own emblem to put there.......I could supply a "blank" round piece of stainless (same as the other inserts on the cover) and you could have it engraved with the RCR logo?
Yes, the flash and digital camera do some strange things with the CF weave, but I assure you that these are near perfection when seen in person.
If you look, you'll see that these covers extend over the throttle body, and the front of the cover only goes up to about the middle of the front coil pack on the LH bank, so it leaves the front couple of inches of the engine un-covered (to clear the rear bulkhead on the GTM.......I believe the SL-C would be similar clearance-wise. The cover has plenty of clearance under it for aftermarket fuel rails (the car in the photo has Trick-flow fuel rails). I have these available in both Pre-Preg Carbon Fiber, as well as fiberglass/black gel-coat. The covers come with the stainless steel inserts shown in the photos. I envision the "dimples" on the top surface to be drilled out and filled with some nice stainless button-head 1/4-20 bolts, just for looks.
Prices for them are:
$439 for CF
$349 for fg/Gel-coat
There is a bit of lead time on these from the time you order until they're completed. If you're interested, please contact me by email under the Contact page of my website. Thanks!
Yes, the flash and digital camera do some strange things with the CF weave, but I assure you that these are near perfection when seen in person.
If you look, you'll see that these covers extend over the throttle body, and the front of the cover only goes up to about the middle of the front coil pack on the LH bank, so it leaves the front couple of inches of the engine un-covered (to clear the rear bulkhead on the GTM.......I believe the SL-C would be similar clearance-wise. The cover has plenty of clearance under it for aftermarket fuel rails (the car in the photo has Trick-flow fuel rails). I have these available in both Pre-Preg Carbon Fiber, as well as fiberglass/black gel-coat. The covers come with the stainless steel inserts shown in the photos. I envision the "dimples" on the top surface to be drilled out and filled with some nice stainless button-head 1/4-20 bolts, just for looks.
Prices for them are:$439 for CF
$349 for fg/Gel-coat
There is a bit of lead time on these from the time you order until they're completed. If you're interested, please contact me by email under the Contact page of my website. Thanks!
