Is this the right flywheel???

[Graham]

This is a couple of pictures of the flywheel that I have. It "should" be for an Audi 016. I am ordering my 302 based engine, so the builder needs the correct flywheel. I appreciate that there isn't much to go on, but the diameter is 29.5 centimetres from tooth to tooth.

I should say that a lot of the kit that I bought wasn't catalogued, hence my issue...

From the piccies, can anyone tell if this is the right??

Cheers guys!!!

Graham.

 

[Mike Huddart]

That's the one.
Mike

 

[Brett James-McCall]

Yep looks like the flywheel I got from Kennedy for my kit. Do you need a spare drive plate and release bearing?

 

[Brett James-McCall]

Here's some pics of mine.

Graham, as a thought, wouldn't your build need the pressure plate, drive plate and release bearing as well?

 

[Graham]

Here's some pics of mine.

Graham, as a thought, wouldn't your build need the pressure plate, drive plate and release bearing as well?

Hi Brett,

Thanks for your help - one less cost
I have the pressure plate (which i guess is the black jobby in your picture, but I need to hunt for the other stuff in my garage of bits. If you get a chance to take a piccy of them, it would help, as I'm not au fait with this part of my build at all ...

Cheers,

Graham.

 

[Brett James-McCall]

Graham,
Like I said, I have a spare drive plate, release bearing and sigot adapator, as I changed mine to fit a 01X. All yours for £20 +P&P

I'll take some pics. Worst case you'll have spares

Brett

 

[Graham]

Graham,
Like I said, I have a spare drive plate, release bearing and sigot adapator, as I changed mine to fit a 01X. All yours for £20 +P&P

I'll take some pics. Worst case you'll have spares

Brett

Sounds good to me! PM me your address, or I can paypal to you?

Cheers,

Graham.