Your project is coming together nicely. I have had the same issue during my mockup fit. I have not tried to tackle that problem yet, (it's really a slight amount of rub) My thought was to adjust the door slightly higher than the spider (just enough to clear the spider) and then have the final adjustment in the latch and striker to tie the alignment together. It should work in theory. Also take as much material off the inside edge of the corner of the door as you can. I hope to be working on my fitment sometime next week, I will keep you posted.I’m still on the fence with the eyebrows. I have a set but not sure if I really like how they look. Unfortunately they don’t cover the area of the door that’s rubbing. I’m debating something that ties into the roll bar to hold the doors in place as I have seen others do.
The part that hits is the corner where it starts to transition from the roof to the side of the car. Both sides hit in the same spot pointed out in the picture