Back home again and wasting no time. I spent the first few days building my chassis table. (Mental note to self) When building large item that needs to be turned over in restricked height make sure to measure said height!!! you guessed it, Made my table and decided to make it 2.4m wide to save cutting on the sheets and and then thought OH!! Shoot!! How high is the roof??? answer, 2.35m !! so I had to do a little mod and now its 2.2m wide and all is good. The casters had not done my uprights, so I had a wee word in their ear and they have now done them and I will pick them up tomorrow. I have started the mould for the gearbox housing and will make that a priority this time home and also to get the hubs and brakes mounted on the uprights. The fuel injection unit I bought was at home waiting and I'm well pleased with the condition of it. To answer a question Jac mac had, The spline count is 31 and the axle is 1 1/4" Not being a Ford man, how does that compare to a 9" axle??. My plan off attack now is to mark out the wheel base, track, engine position and tub layout on the table. I have a dummy block and I will fab up the rear bulkhead and engine mount and work forward with the tub, I will make brackets to hold the hubs and upright's in the right position for track/wheel base and then build the "A"arms and trailing arms etc to suit. I have put a couple of pics of the table and Injection in and will post photos of the uprights in couple of days. Cheers Leonmac.