Need some rough transaxle lengths

[Adam Hennessy]

Anyone got a few minutes and a tape measure to go get a transaxle dimension. Just need the length, bellhousing to tailstock, of an Audi o1E and o16 Rough measurement is all that's needed +/- 1-2 inches is fine...

Working on a different tranny venture in my car that may help some of you guys out

Thanks!

 

[Graeme Stebbing]

Hi Adam, Maybe these will help, not sure where i found them but full credit to the original poster.

Regards
Lambo

 

[Scott]

Anyone got a few minutes and a tape measure to go get a transaxle dimension. Just need the length, bellhousing to tailstock, of an Audi o1E and o16 Rough measurement is all that's needed +/- 1-2 inches is fine...

Working on a different tranny venture in my car that may help some of you guys out

Thanks!

I can get you these dims for the 01E tomorrow.

 

[Scott]

I can get you these dims for the 01E tomorrow.

Length of the FWD unit is 26 1/2 inches from bell housing to rear tail.

The AWD version adds 12 inches to that.

 

[Adam Hennessy]

Much appreciated. I'll compare these to S6MT tomorrow and see what the difference is..

-Adam

 

[Adam Hennessy]

Hey what's a rough maximum length of transaxle you guys can get away using on your chassis without protruding from the rear too far??

Just curious