Since I have a lot of photos, lets get started. The info I give could be eronious, so if someone knows of these cars, give a shout as to how they are attached or anything pertinent.
Here is 1061
Hard to tell but these are braced at the front, and I can't tell but they are probably just bolted to the body.
Here is one of the SAAC cars and theirs is supported with an adjustable rod.
Here is a Superformance treatment, also suported.
Here is 1083. This canard is bolted to the body, don't know if it goes to the inside of the fiberglass.
Here is 1043
Here is another original.It is attached above and below the canard, and is straight.
1079
1036
An unkown
Here is Kim's car.
Howard's car. These are curved.
Here is 2135 showing the bracing.
Here are some of the blanks that I believe Ian was going to furnish??
One of the attachments
Here are drawings that I think Howard furnished to me. Its been a while!! I liked this version because it had the up sweep to it. I also like the way it is proportional to the width of the tire. Some stick out too far and that could be dangerous to any walking by. I plan(for now) to attach it through the fender, adding a lip to the outside and bolting through the fiberglass. It will either be sheet metal of stainless. I did a paper cutout and taped it to the fender to see how it looks, and I like it. Now to cut through the fiberglass:stunned:
Bill