Well, my full 7 day week of working on the SLC is over, wife starts her class tonight. It will be slower paced class, so should have some evening I'll be able to get out to the shop at least. I got about 90% of the stuff I wanted to do done. I ended up not going out there Friday so we could watch a movie in the movie room after the kid was in bed.
I still need to remove my emblems and the 3M emblem tape off of them as it's a little too thick so with the car being so low, you can see the gap between emblem and body. This time around I'll use 3M 468MP. I'll reinstall the SLC IR/8 emblems, plus add the fender emblems (finally) as well as the nose emblem. I have a SLC emblem for above the android screen, still can't decide if I want body color or orange.... Opinions?
Was able to wash the car for the first time since it was delivered. Sadly it took me 4 months to actually do, but it's been low on the priority list as it never looked "that" dirty. After removing the headlight lens, I realized how bad it really was so it got moved to the top. I was sort of surprised how easy it was to wash and quickly learned not to put much water or soap by the windows as it'll get inside. I still plan to get them tinted, 35%, so maybe with some tint I can use something to seal the windows up and the tint will hide it. Figure worse case I'll sketch and draw a frit for them and get it cut out of vinyl to apply after the tint, may do this either way.
H-D LED signal boards DO actually fit, at least with the cheap clear lens I bought. The lens had a LED board inside them, but a good buddy was able to mill that junk out so all that was left was the lens. I sanded/grinded the outside ring of of the H-D LED boards down and just so happen to fit perfectly inside the lens so everything can be flush mounted. I still plan to replace those lenses with some 3D printed ones that have the rounded edges so they match the profile of the 4 headlights. Really no point, but I like to have things match if it's possible. I did attempt to tint the clear lenses for now with VHT Nightshades, but didn't come out as I expected. I was going to wet sand and polish them, but dont' think I'll waste the time since I'm making new ones. The H-D signal board running lights are pretty bright compared to the headlights unless you're below the cutoff, the tint will tone them down a bit when I install them. Soldered the wiring for the signals when I installed them.
Looking forward to Black Friday in a month, I'm hoping TRS has their big 20-25% off entire website sale and if so I'll suck it up and get the matching JW high beams. Again to keep things looking the same.
Before washing the car, while it was out of the shop I was able to officially test the range of the Viper keyless entry with the foil around the antenna. Works the same distance as it did in the shop, so think I'm good! Sucks I can't use the full range, but better safe than sorry.