Kyle,Looking for ideas/part numbers for the LS drivers side water pump hose. The 90 slim hose with preferably a long leg.
I used this from Pegasus Racing.
It is definitely a very tight fit at the front of the engine.
Kyle,Looking for ideas/part numbers for the LS drivers side water pump hose. The 90 slim hose with preferably a long leg.
I used a easyguard keyless pushbutton with the Coach-1, very issues to get wired up using the manual from the system.
Perfect thank you. Ya I elected for the coupe 23 board. No windows or locks on the car, just door actuators. I also didn’t feel like I needed the auto dimming lights etc.Yep, that's me. I'm traveling for work today, but should be home in a day or two and can double check my wiring for you. It looks like you have a different coach board than me, however I'm sure it works the same. Most of the coach switches are ground based, but those for the ignition switch are 12+, so you can just run the Acc, Run, and Start wires from the EasyGuard into the Coach.
The other white connectors, Horn, Low Beam, Hi Beam, and Neutral are ground signals. I think the Fan Hi is a 12+ as well.
I saw this post but it never really resonated with me until now. Maybe I can commission him to make some more, otherwise I’ll have to craft up something else.Kyle,
Making good progress.
Check out Kurt’s post #119 for inboard seat brackets that move the seat over as much as 1.5”:
Kurt H (hoffkm) SL-C build thread
Yay, the wiring is complete (for now) or at least as far as I can go for now. Many builders have run wiring on top of the footbox beneath the dash panel. I chose to run all my wiring inside the footbox so I can still access it with the dash panel in place. This was not easy for me to get to...www.gt40s.com
I saw this post but it never really resonated with me until now. Maybe I can commission him to make some more, otherwise I’ll have to craft up something else.
That will be my next item to order, completely forgot about those things, I guess I need them!Kyle
During my build I shoved my seat inboard but forgot to consider seatbelt hookup. That forced me to go back outboard some. Hopefully that is a consideration in your design.
I might have to do that Dan, thanks!Kyle
Just a thought on the shifter. I bent my shift rod about 20 degrees aft so I could move the shift box forward and to give my hand more room when shifting forward. I kept hitting the dash with my knuckles. Again, just a thought.