Problem solved!
A center panel with aft facing punched louvers would be nice:idea: also.
Well not quite. I had a go tonight to see if I could use the off cut from the floor but just a little too short in the end. I'll leave it for now and continue with the rest of the panelling and put it on my list of jobs to revisit.
Also quick question for everyone. What's the best procedure for fixing the alu panels? I was going to do the following:
1) Cut panel to size and mark out spaces for rivets
2) Clamp panel in place on chassis
3) Drill two of the holes at opposite ends of the panel and fix with clecos to keep in place.
4) Lift the panel and put down a bead of sealant all the way around where the panel meets the chassis frame.
5) Rest panel back down, clamp and drill remaining holes
6) Rivet panel into place
7) remove the 2 clecos and rivet the last two holes.
Apologies if this is a dumb question but I've never done anything like this before and I want to do it right.
Also with the sealent should it go in the centre of the chassis rail? If so won't this be in direct line with where the holes will be drilled?
Trev