Kurt, Appreciate all the help! So I went back out shortly after my post and messed with it more. It turns out I need about another 1.5g more. I think I’m at 6 or so gallons of water. I wanted to keep the system simple so I do not have bleed lines. What I did was massage the return hose at the radiator which allowed me to force all that air out. I then open my steam vents on the engine and got some air out of there too. Once that water pump worked out the air pocket it was hovering around 190.
also as far as injectors go, I’m going to replace the 22lb stock ones for some flex fuel injectors that are 55lb. That should drop my duty cycle significantly and most definitely max out the HP potential with this setup.
The start button is ok for now. It is a proximity key. I may pony up for the key fob type that powers on when you are near the vehicle.
I plan to use power actuated doors with a simple relay, they are going to have to be powered continuously, hoped they don’t draw many amps.
As far as the screeching goes, it might have been the new rear main seal. I’m assuming until it got some proper lubricant it didn’t like being dry. It seems to have resolved itself.
Something I’ll for sure have to do is wrap all of my ECU wiring in heat protection and get myheaders ceramic coates
also as far as injectors go, I’m going to replace the 22lb stock ones for some flex fuel injectors that are 55lb. That should drop my duty cycle significantly and most definitely max out the HP potential with this setup.
The start button is ok for now. It is a proximity key. I may pony up for the key fob type that powers on when you are near the vehicle.
I plan to use power actuated doors with a simple relay, they are going to have to be powered continuously, hoped they don’t draw many amps.
As far as the screeching goes, it might have been the new rear main seal. I’m assuming until it got some proper lubricant it didn’t like being dry. It seems to have resolved itself.
Something I’ll for sure have to do is wrap all of my ECU wiring in heat protection and get myheaders ceramic coates
Last edited: